It is a case for stickey4 v2 only.
same product
·Case・ Screw (6mm): 6
・ Rubber feet: 4 pieces
Build guide
1. Remove the lower 6 screws (7mm)
2. Do not use middle plate and bottom plate
3. Insert the board into the case (if the BMP slide switch is attached, it will hit, so insert it from the switch side).
4. Install the plate of your choice
5. Fasten the screw (6mm). Please note that the length is different from the screws included in the kit.
6. Attach rubber feet to your liking
7. Done!
Precautions
The photo is a sample created and is not the same as the product content.
Specifications are subject to change without notice.
If you have any questions about defective parts, missing parts, etc.Inquiry formPlease contact us from.